FAVI RioHD-LED-2 User Manual - page 10
8
9
Front projection
Table mount
Rear projection
Table mount
screen
screen
projector
projector
The projector is angled
too far to the right.
The projector is angled
too far to the left
The projector is s
et up
correctly.
The following diagrams are examples of how your projector can be set up for use.
For the best image results, the projector should be directly facing the screen. Adjustments to
the focus and keystone controls will help to improve the image quality.
The projec
tor’s keystone
control needs to be adjusted.
Focus adjustment
Keystone correction
1
2
Rotating the lens clockwise will make it retract into the
projector, while rotating it counter clockwise will make it
extend.
Front height foot adjustment
Rotating the front height adjustment foot
counter clockwise will allow the foot to extend,
and will raise the front height of the projector.
The foot’s maximum extension is 1.5 inches.
Continuing to rotate it will remove the foot from
the projector. If this happens, you can simply
screw it back in. Once you have adjusted the
front height, you may need to readjust the key-
stone correction.
Projector setup
Image adjustment
After setting up your projector and powering it on, the
image may look trapezoid shaped even after the
projectopr is properly positioned. You can adjust the
keystone adjustment wheel to correct the image. The
keystone adjustment wheel is located on the bottom
of your projector. (Please see page 3) Gently move
the wheel either left or right to adjust the keystone
correction.