FAVI RioHD-LED-2 User Manual - page 6
13
4
V ideo
S-video
Y /PB /PR
V GA
HDM I
Selecting a video mode
Press the “AV/TV” button on the remote control to bring up the following menu screen:
This menu screen will appear in the upper right hand corner of the image. Use the up and down arrow buttons
to highlight the selection you want, then press the right arrow button to switch over to that video mode.
Powering on/off your projector
After plugging your projector in, press the power button on either the remote control, or the projector. To turn
the projector off, press the power button twice.
Problem:
Solution:
Troubleshooting
Getting started (continued)
If you have any issues setting up or using your RioHD-LED-2, before contacting us please refer to the
following troubleshooting guide:
Projector will not power on.
Make sure that the power supply is plugged in
correctly. The power supply has a built in
indicator LED which should glow when plugged
in.
Projector powers up but only displays a screen
that says “NO SYNC”.
Check your video source selection and video
cable connections.
I can’t get the projector to change from one
video mode to another.
Make sure you are pressing the right navigation
arrow button to select the video mode that you
want. Pressing the MENU button will only close
the source selection menu.
I connected my projector to my stereo with an
adapter cable, and the sound is distorted.
Try setting the projector’s volume to 50% or lower,
and use your stereo’s volume control to adjust the
volume.