FeiYu Tech SUMMON User Manual - Ii How to Use Summon
II How to use Summon
1. Function introduction of buttons and ports
1
Install battery
Power on:
Single click the function button
on control panel for power on.
Power off:
Long press the function button
for three seconds for power off
and the indicator light turns off.
If the battery power is low, the
screen shall turn off automatically,
please long press the function
button for three seconds so as to
make sure the unit completely
powers off. Then you can recharge
or replace the battery.
Remove the hand
shank and insert one
22650 battery into it.
Single tap this button to switch
below camera mode and
record mode.
Long press this button to open
WiFi function, and long press
again to turn off WiFi function.
The default is record mode.
The function button on
control panel can control
power on and power off.
2
Power on and
power off
!
Connect to a computer
with USB data cable so
as to read the video and
picture files in a SD card.
SD reading port
Connect with USB data cable by this
port to upgrade firmware or charge
the battery.
Please refer to “firmware upgrade”
for the operation of firmware upgrade.
Please refer to “charging mode” for
the charging mode.
USB port
How to use Summon
2
Camera / Record
switchover button
USB port