Fender Acoustasonic Junior Operating Instructions Manual - page 7
DEUTSCH
DEUTSCH
IT
ALIANO
IT
ALIANO
FRAN
ç
AIS
ESP
AÑOL
ESP
AÑOL
ENGLISH
ENGLISH
FRAN
ç
AIS
A. LINE CORD - The power line
cord must be connected to a
grounded AC receptacle in
accordance with the voltage and
frequency ratings as listed on
the rear panel under INPUT
POWER.
B. FOOTSWITCH - Plug-in con-
nection for the optional remote
footswitch (P/N 037659) used to
switch ON/OFF the chorus
effect. Using this jack will over-
ride the chorus select switch on the front panel. NOTE: Any good qual-
ity patch cord will work with the remote footswitch, however an
unshielded speaker type cord is preferable to a coax guitar cord.
C. RETURN - This 1/4-inch, stereo, TRS (Tip=Left, Ring=Right,
Sleeve=Ground), line-level input jack is designed to accept signal from
an external processing device, such as a digital delay or a chorus unit.
D. SEND - This 1/4-inch, stereo, TRS,
line-level output jack is designed to
feed the Acoustasonic Junior’s
effects bus to an external signal
processing device, such as a digital
delay or a chorus unit. On the
Acoustasonic Junior, the tip is left
and the ring is right. This jack can
also be used as a line out.
E. INSTRUMENT INSERT - This
1/4-inch, unbalanced, input/output,
line-level phone jack is designed
for use with a signal processing
device, such as a digital delay or
Reverb unit. A special "Y" line cord
(stereo to dual mono) is required to
use this TRS jack (Tip=Send,
Ring=Return, Sleeve=Ground).
R
R
R
R
e
e
e
e
a
a
a
a
r
r
r
r
P
P
P
P
a
a
a
a
n
n
n
n
e
e
e
e
ll
ll
F
F
F
F
u
u
u
u
n
n
n
n
c
c
c
c
tt
tt
ii
ii
o
o
o
o
n
n
n
n
s
s
s
s
S
S
S
S
p
p
p
p
e
e
e
e
c
c
c
c
ii
ii
ff
ff
ii
ii
c
c
c
c
a
a
a
a
tt
tt
ii
ii
o
o
o
o
n
n
n
n
s
s
s
s
A
B
C
D
E
TYPE:
PR 334
PART NUMBER:
022-1302-000 (120V, 60Hz) USA
022-1332-000 (240V, 50 Hz) Aust
022-1342-000 (230V, 50 Hz) UK
022-1362-000 (230V, 50 Hz) Eur
022-1372-000 (100V, 50/60 Hz) Jpn
POWER REQUIREMENTS:
300W
POWER AMPLIFIER SECTION
POWER OUTPUT:
40W R.M.S. per channel, (80W R.M.S. Total)
into 8
Ω
@ <.12 t.h.d. both channels driven>
SENSITIVITY :
640mV @ stereo effects return (both channels)
PREAMP SECTION
INPUT IMPEDANCE:
10M
Ω
(Inst), 3.6k
Ω
(Mic), 36.4k
Ω
(Line/Inst)
SENSITIVITY FOR FULL POWER: 12.75mV (Inst),
5mV (Mic),
50mV (Line/Inst)
TONE CONTROLS:
Treble:
+/-15dB @ 15kHz (Inst),
+/-15dB @ 15kHz (Mic, Line/Inst)
Mid:
+/-12dB @ 1kHz (Inst)
Bass:
+/-12dB @ 100Hz (Inst),
+/-12dB @ 50Hz (Mic, Line/Inst)
FEEDBACK NOTCH:
-10dB from 80Hz to 700Hz
STRING DYNAMICS:
0 to -15dB @ 6.3kHz
PHANTOM VOLTAGE:
+15V DC (Mic)
SPEAKER COMPLIMENT:
Two Fender Special Design 8” speaker (P/N 051016)
Single Piezo Horn (P/N 049260)
DIMENSIONS:
Height:
15.5 in
(39 cm)
Width:
22.4 in
(57 cm)
Depth:
10.2 in
(26 cm)
WEIGHT:
43 lb
(19.5 kg)
Product specifications are subject to change without notice.
7