Festool ETS 150/5 EQ Instruction Manual - page 9
9
materials and the grinding material is hot after
long periods of work.
– Always use original Festool sanding pads. For-
eign pads are not suitable for the speed of the
sander and may break.
– If the power tool is dropped or falls, check for
damage to the machine and sanding pad. Re-
move the sanding pad for closer inspection. Re-
pair damaged parts before using again. Broken
sanding pads and damaged machines can cause
injuries and machine instability.
Mixed dust containing metal and sanding
damp surfaces
With mixed dust containing metal (such as
dust resulting from paint sanding in the au-
tomotive field) and when sanding damp sur-
faces, the following measures must be ob-
served for reasons of safety:
– Install a residual-current circuit breaker (GFCI,
PRCD) upstream.
– Connect the machine to a suitable dust extractor.
– Regularly blow out the motor housing of the ma-
chine to remove dust deposits.
Health hazard by dust
WARNING! Various dust created by power
sanding, sawing, grinding, drilling and other
construction activities contains chemicals
known (to the State of California) to cause cancer,
birth defects or other reproductive harm. Some ex-
amples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and
other masonry products, and
• arsenic and chromium from chemically treated
lumber.
The risk from these exposures
varies, depending on how often
you do this type of work. To re-
duce your exposure to these
chemicals: work in a well ven-
tilated area, and work with ap-
proved safety equipment, such as dust masks that
are specially designed to filter out microscopic par-
ticles. Wash hands after handling.
Intended use
The sanders are designed for sanding wood, plas-
tic, composite, paint/varnish, filler and similar ma-
terials as directed. With mixed dust containing met-
al (such as dust resulting from paint sanding in the
automotive industry) and when sanding damp sur-
faces, special safety instructions must be followed.
The sanders are not intended to be suitable for
grinding bare metal. Material containing asbestos
cannot be processed.
The user is liable for improper or non-in-
tended use.
Technical data
Wear protective goggles.
WARNING
TO REDUCE THE RISK OF INJURY, USER MUST
READ INSTRUCTION MANUAL.
Eccentric sander
ETS EC 150/3 EQ
ETS EC 150/5 EQ
Power
400 W
400 W
Idle speed
6000 - 10000 min
-1
6000 - 10000 min
-1
Sanding stroke
3.0 mm (0.12 in.)
5.0 mm (0.20 in.)
Sanding pad
D 150 mm (5.9 in.)
D 150 mm (5.9 in.)
Weight (without mains cable, with sanding pad)
1.2 kg (2.65 lb)
1.2 kg (2.65 lb)
Safety class
/II
/II