Fezz Audio Silver Luna Prestige User Manual - page 10
10
Any and all connections must be made whilst the device is disconnected from the
mains power supply. Before making any such connections, make sure that the
amplifier is switched off.
HOOK-UP OF THE POWER SUPPLY CORD
Make sure that the amplifier is switched off. Connect the power cord to the IEC
socket on the rear panel of the amplifier.
The amplifier is designed to operate at a rated voltage of 230V / 50Hz. Connecting
the device to a mains network with incorrect parameters can lead to damage that is
not covered by manufacturers warranty
HOOK-UP OF THE SIGNAL SOURCES
Connect the signal source to the amplifier inputs IN1, IN2 or IN3. Select the source of
input signal by rotating the input selector located on the front panel of the amplifier.
In order to achieve the highest sound quality, use only high-quality RCA cables. Pay
attention to the proper connection and distinction of the right (R) and the left (L)
channels.
WARNING! To connect a turntable, you need to use an external
phono MC/MM preamplifier or a turntable with a built-in
preamplifier.
HOOK-UP OF THE SPEAKERS
Check the impedance of the speaker set that you posses. Connect the speaker cable to
the appropriate terminals on the rear panel of the amplifier. Depending on the
impedance of the speakers that you posses, connect it to the terminal marked either
4Ω or 8Ω. If your speaker impedance is 6Ω - connect the speaker wire to the terminal
8Ω.