Freedom Concepts AS 2000 Owner's manual - page 14
A
B1
B2
B3
G E A R S H I F T I N G A N D C R A N K / S P R O C K E T A D J U S T M E N T S
REAR CONTROL GEAR TRANSFER
If the cable starts to stretch through normal use, quick
adjustments can retighten the slack.
1. Shift to neutral position (B1).
2. Loosen lock nut (C) and turn barrel adjuster (D)
until loose slacking cable is tight.
3. Tighten lock nut (C).
13
E
F
C
D
G
H
THUMB PEDAL CONTROL SHIFTER
OPERATION
Tandem bikes allow the option for both
riders to pedal the bike at the same time.
When the shifter (A) on the handlebar is
closest to the rider the (B1) setting has
the front sprocket in a neutral position
and the front rider doesn’t contribute to
the propulsion of the bike. Pushing the
shifter (A) forward once to the (B2) position
engages the front sprocket at a low setting
so the front rider can contribute. Moving
the shifter (A) forward once again to the (B3)
position changes the sprocket to the high
setting for more contribution from the front
rider. Moving the shifter in reverse adjusts
the setting back to the beginning.
THUMB/FINGER GEAR
SHIFTER OPERATION
Change gears up or down
with an easy click. Using
your thumb, push shifter
lever (E) forward. With each
click you raise a gear. Using
your inger, pull shifter
lever (F) and with each click,
you lower a gear.
3-SPEED CABLE ADJUSTMENT
If the cable starts to stretch through
normal use, quick adjustments can
retighten the slack.
1. Shift to gear three.
2. Loosen lock nut (G) and turn barrel
adjuster (H) until loose slacking
cable is tight.
3. Tighten lock nut (G).