Freedom Concepts AS 2000 Owner's manual - page 17
16
B R A K I N G ( A D J U S T M E N T S A N D O P E R A T I O N S )
PARKING BACK BRAKE
(Not available for DCP Mini’s)
Parking brakes are available
for one or both rear wheels
on most bike models.
Parking brakes are ideal for
transporting riders on or off
the bike, by stabilizing the
bike movement. To use
the parking brake, simply
push the brake lever
down to lock and lift
up to release.
When transporting
someone on or off the
bike, always squeeze brake
handle (D) and push in pin
(E) to lock brake. This helps
to stabilize the bike. To
release brake lock, squeeze
handle (D).
BB: DUAL BRAKE CABLE
JUNCTION BLOCK
ADJUSTMENTS
1. Loosen the locknut (A) by
turning counterclockwise.
2. Turn the barrel adjuster (B)
clockwise to tighten and
counterclockwise to loosen
brake sensitivity.
Please note: When squeezing
the brake lever to apply the
brakes, the lever should not
touch the handlebar when
closed.
3. Turn locknut (A) clockwise
until tight.
Caution: Over-tightening
cable will cause brake pads to
constantly rub on wheels.
For instructions on
cable adjustments
to the calipers, follow
caliper brake tension
adjustments on page 17.
AA
AA: HAND BRAKE TENSION ADJUSTMENTS
1. Loosen the locknut (A) by turning away from
housing (B).
2. Turn the barrel adjuster (C) towards the housing to
loosen and away to tighten brake sensitivity.
Please note: when squeezing to apply the brakes,
the brake lever should not touch the handlebar.
3. Turn locknut (A) clockwise until tight.
Caution: Over-tightening
cable will cause
brake pads to
constantly rub
on wheels.
BB
A
C
B
E
D
A
B
Cable to brake
Rider 2
brake control
Rider 1 brake control