Freedom Concepts AS 2000 Owner's manual - page 6
G
H
F
Learn More With Our
How-To Videos.
Scan the QR Code
with your phone and you
will be linked to our
Ready to Ride Video Series.
S T R A P S , H A R N E S S E S A N D F O O T P L A T E S
HANDCYCLE FOOTPLATE
HEIGHT ADJUSTMENT
Once the handpedals and seat positioning have been
determined, the footplates can be adjusted. The
footplate can be positioned vertically at any height
along the top or bottom of the vertical posts for
optimal leg support and comfort.
1. To move the footplates (A), turn the thumbscrew (B)
under each footplate counter clockwise until loose.
2. Then slide the footplate (A) up or down the post
(C1 or C2) to the desired height. Re-tighten the
thumbscrew (A).
3. To move the footplates (A) from the bottom post
(C1) to the top post (C2) you need to remove the
safety hitch pin (D). Simply pull the pin (D) straight
out in a horizontal motion away from the post.
Your safety hitch pin is provided to ensure you do
not lose the footplates should you not tighten the
thumbscrews (B) properly.
4. The frame clamp can also be
adjusted to move the footplates
forward or backwards. Two 1/2”
wrenches are required to
loosen the bottom clamp
bolts (E) for repositioning
to the desired location on
the bike.
5
A
B
D
C1
C2
E
CHEST HARNESS STRAPS
Four #2 Robertson wood screws
(F) are used to secure the chest
harness to the seat back.
Always wear shoes when
riding to protect the feet.
Secure the foot irst by
positioning the heel at the
back of the foot plate (G)
and then attaching the
straps (H) around the foot
until snug.