G.I.T P5000 series Installation Manual - Programming Examples
14
PROGRAMMING EXAMPLES
EXAMPLE 2, OPTION 20: TRANSMITTER CODE LEARNING
The transmitter supplied is already programmed to the system. This option allows you to add more transmitters to your
system if needed.
1. Access programming mode (see programming procedure).
2. Press and release program button 20 times and count 20 beeps.
3. Depress brake pedal to confirm.
4. Press
button on the transmitter. You will hear 5 beeps. The new transmitter code is learned. If you press on the
same transmitter 4 times, all another previously stored transmitter codes in the system will be erased.
5. Turn ignition OFF to exit programming mode.
EXAMPLE 3, OPTION 1A: TACH LEARNING
The factory default setting should normally operate with most vehicles on the market. Note that some vehicles equipped with
multi coil system have a very low TACH signal. In that case, the TACH learning feature will allow the system to adjust itself to
the TACH signal of the vehicle.
Important note: engine must be warm and at idle speed (approximately 800 rpm) before proceeding with TACH
learning, otherwise preheat engine for at least 10 minutes before processing.
1. Access programming mode (see programming procedure).
2. Press then release the antenna button 1 time and count 1 beep.
3. Depress brake pedal to confirm, you should hear 3 beeps, (factory default setting) Blue L.E.D. will flash rapidly.
4. Start the engine and wait for the lowest idle.
5. Press
button on the transmitter, you should hear 1 beep, TACH signal has been learned.
6. Turn ignition OFF to exit programming mode.