G.I.T P5000 series Installation Manual - Programming Options
9
PROGRAMMING OPTIONS
OPTION 1A: TACH LEARNING ( SEE EXAMPLE #3 )
The factory default setting should normally adapt to most vehicles on the market. After the installation is completed, start
engine with transmitter and most of the time you will have a perfect start. If the starter motor is over crank or release too fast,
you must process with the TACH learning option or manual fine-tuning.
OPTION 1B: TACH FINE TUNING ( SEE EXAMPLE #4 )
Occasionally with factory default setting or TACH learning feature you might not reach the exact performance. This option
allows you to fine-tuning the TACH signal manually.
When this option is set for 10 beeps, the system will detect alternator DC voltage as valid Tachometer.
OPTION 2: CRANKING ADJUSTMENT
If you expect that the vehicle needs adjusting you can force the starter to slightly under crank or over crank. This adjustment may be
necessary in some older vehicles or vehicles with diesel engines to help the engine start in extremely cold weather conditions.
OPTION 3: AUDIBLE ARMING / DISARMING
When this option is enabled, the system will chirp every time when system arms or disarms.
OPTION 4: RUNNING TIME DURATION
This option allows you to set the remote start engine running time for 10, 15 or 25 minutes. When remote started, the engine
will run for the selected amount of time.
OPTION 5: POWER AUXILIARY OUTPUT
This option allows you to set the AUXILIARY OUTPUT as:
1: 2
nd
ignition
2: 2
nd
accessory
3: 2
nd
starter