G.I.T P5000 series Installation Manual - Programming
6
PROGRAMMING
Our remote starteris delivered with factory default settings. You can install it without programming or you can modify the
configuration to suit your customer’s need. Important: the installation must be completed before accessing
programming mode.
Programming the system:
1. Turn the ignition 3 times OFF to ON and leave the key in the ON position (engine not running).
2. Within 15 seconds, push 1 time on the antenna button. You will hear 5 beeps to confirm that the system is now in
programming mode. The L.E.D. built-in receiver will flash slowly.
Note:
If the 15 seconds delay has expired, just turn the ignition OFF and repeat steps 1 and 2.
The system has 20 programmable options and there are 1 to 3 different possibilities to modify.
Step 1
Press then release antenna button to select option 1 to 20 (depend on models, see programming chart).
Every time you press on receiver button you will hear one beep. Count the beep to reach desired option.
Step 2
When you have reached the desired option depress brake pedal to confirm.
Step 3
Press button
,
or
on transmitter to choose between different possibilities (
to select column 1, you
will hear 1 beep,
to selectcolumn 2, you will hear 2 beeps or
to selectcolumn 3, you will hear 3 beeps).
Depress brake pedal again and count the beep to confirm that the feature has been changed.
Note: if you have more than one option to modify, repeat steps 1 to 3.
Step 4
When finished, Turn ignition OFF to exit programming mode. One long beep will be emitted.