G-Lite Luxury PP-8600 User Manual - page 6
6
STEP 5
: .
Screw the handle bar to the stand tube tightly,
Pull out the endcap (23) for the wiring hole
on the rear of the stand tube (19)
STEP 6
Fix the hand-pulse wire (8)
Ε
(16) to the endcap for wiring
hole, make it enter through the wiring hole on the rear of st-
and tube, make the terminals of the wire be out of the stand
tube then mount the endcap to the corresponding holes on
the stand tube.
STEP 7
:
Connect the down-leads of the computer to that of stand
tube and the hand-pulse down-lead of the handle bar.
STEP 8
:
Mount the computer (13) onto the stand tube and screw
hem together with flat washer(14),
spring washer(15) and bolt(18).
STEP 9
:
Mount the ornament cover to the back of the handle tube,
Insert the power cord to the plug on the rear of the main
unit, then you can enjoy the ENERGY BOARD.
Make sure that all parts are tightened before you use the Energy Board.
To protect the floor or carpet from damage, place a mat under the Energy
Board.