Gaggenau BS 470 Instruction Manual - page 32
32
Trouble shooting
Malfunctions often have simple explanations. Please
read the following notes before calling the after-sales
service.
ã
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out by one of our trained after-sales engineers.
If the appliance is faulty, unplug the mains plug or
switch off the fuse in the fuse box. Contact the after-
sales service.
Disruption
Possible cause
Solution
Appliance not working, no display
Plug not inserted
Connect the appliance to the electricity
mains
Power failure
Check whether other kitchen appliances
are working
Fuse defective
Check in the fuse box whether the fuse
for the appliance is in working order
Operating error
Switch off the fuse for the appliance in
the fuse box and switch it on again after
about 60 seconds
Appliance cannot be started
Appliance door is not quite closed
Close appliance door
Appliance does not work, display does
not respond.
0
appears in the display
Child lock activated
Deactivate the child lock (refer to
Child
lock
section)
Appliance switches off on its own
Safety shut-off: the appliance has not
been operated for longer than 12 hours
Confirm the message with
™
, switch off
the appliance and set it again.
Appliance does not heat up,
°
appears
in the display
Appliance is in demo mode
Deactivate the demo mode in the basic
settings
The appliance cannot be started, a mes-
sage is shown on the display
No water available in the appliance
Check the water connection
No steam visible in the oven
Steam above 100°C is invisible
This is normal
The grilling surface only lights up
around the sides, not in the middle
Only the side of the grilling surface is
heated to allow for better heat distribu-
tion
This is normal
The "steam removal"
3
symbol does not
appear on the display
The steam removal function is only avail-
able if the oven temperature is below
130°C
This is normal
A lot of steam escapes at the top of the
door
Appliance is calibrating the boiling point
or is preheating or the heating mode has
been changed
This is normal
The appliance has not yet been cali-
brated
Calibrate the appliance
A lot of steam escapes at the side of the
door
Door seal soiled or loose
Clean the door seal and insert it in the
groove
Humming noise when switching on
The drain pump starts to operate
This is normal
Appliance has been switched off for sev-
eral days
This is normal: automatic rinsing when
being switched on again
There is a "pop" noise during cooking
Cold/warm effect with frozen food,
caused by the steam
This is normal
The appliance is not producing steam
properly
Limescale has formed in the appliance
Start the descaling programme