Gaggenau BSP 220 Instruction Manual - page 12
12
4
Confirm with
™
.
Ending initial set-up
The display shows "Initial set-up complete. Calibrate
the appliance before cooking for the first time".
Confirm with
™
.
The appliance enters standby mode and the standby
screen appears. The appliance is now ready to use.
Calibrate the appliance before steaming for the first
time. The appliance sets the boiling point.
Calibration
The boiling point of water depends on barometric
pressure. As air pressure drops with increasing
elevation, the boiling point drops as well. During
calibration, the appliance sets the boiling point to the
pressure conditions at the place where it is installed.
It is important that the appliance steams without
interruption for 20 minutes at 100°C. Do not open the
appliance door during this time.
Notes
‒
Calibrate the appliance only when it is cold.
‒
During calibration, the appliance generates more
steam than it normally would do.
1
Turn the function selector to S.
2
Select "Basic settings" using the rotary selector.
3
Touch the
™
symbol.
4
Select "Calibration" using the rotary selector.
5
Touch the
%
symbol.
6
Fill the water tank with cold water and touch the
™
symbol.
7
Remove all accessories from the oven interior and
touch the
™
symbol.
8
The duration of 20.00 minutes appears. Touch
I
to start calibration.
Calibration begins. The elapsing time is shown on the
display.
Note: Do not interrupt calibration. Do not turn the
function selector. Do not open the appliance door.
A message appears in the display once calibration has
ended. Touch
™
to confirm and turn the function
selector to 0.
After moving house
Repeat calibration so that the appliance adapts
automatically to the new installation location.
After resetting to the factory settings
After resetting to the factory settings in the basic
settings menu, you must repeat calibration.
Following a power cut
The appliance saves the calibration settings even in
the event of a power cut or disconnection from the
mains. Recalibration is not necessary.
Cleaning accessories
Before using the accessories for the first time, clean
them thoroughly using hot detergent solution and a
soft cloth.
:DWHUKDUGQHVV
3OHDVHFDOLEUDWHWKHDSSOLDQFH
EHIRUHILUVWFRRNLQJ
,QLWLDOVHWXSFRPSOHWH
&DOLEUDWLRQ
&$/
&$/