Gaggenau VG 295 CA Installation Instructions Manual - page 10
10
7
Fit the cooktop and screw it down evenly. Fit
burner parts and pot supports, paying attention to
correct positioning.
8
Set the pressure regulator to the correct pressure
(see “Connect gas supply”).
Changing the full burn nozzle: wok burner
1
Remove securing clips on the burner pipes.
Remove burner pipes. Loosen screw on air-
regulating tube. Remove nozzle fitting.
2
Remove nozzle and O-ring for inner circular
burner by hand. Unscrew nozzle for outer circular
burner (SW10).
3
Check that O-ring is correctly positioned in new
full-burn nozzle for inner circular burner. Push
nozzle onto burner pipe. Screw new main nozzle
for outer circular burner all the way into nozzle
fitting.
4
Put on nozzle fitting and burner pipes. Put on
securing clips.
5
Set air-regulating tube to correct dimension after
loosening the screw (see nozzle table). Tighten
screw again.
6
Put stovetop in place and screw it tight. Put on
control knobs. Put burner parts and pan supports
in place, positioning them correctly.
If it should be necessary to correct the low-setting
nozzle as the result of deviating gas types and
pressure, the flow rate can be increased by turning to
the left.
These burners do not require the primary air to be
adjusted.
Checking functions after the conversion:
The flames are adjusted correctly if no yellow tips are
visible. They must not go out when switching over
swiftly from the high to the low setting.
Note: Stick the adhesive label included with the
nozzle set over the rating plate of the appliance to
document the changeover to a different gas type.
Customer service
If your appliance needs repairs, our customer service
is there for you. We work hard to help solve problems
quickly and without unnecessary service calls, getting
your appliance back up and running correctly in the
least amount of time possible.
When you call, please indicate the product number
(E-Nr.) and serial number (FD-Nr.) so that we can
support you in a qualified manner. You will find the
type plate with these numbers on the bottom of the
appliance. To avoid having to search for a long time
when you need it, you can enter your appliance data
and the customer support telephone number here.
Please read the installation instructions and use and
care instructions provided with your appliance. Failure
to do so may result in an error in using the appliance.
This could result in a service call that instead of fixing
a mechanical issue is only needed for customer
education. Such calls are not covered by the
appliance warranty.
Please find the contact data of all countries in the
enclosed customer service list.
To book an engineer visit and product advice
You can rely on the manufacturer’s expertise. Rest
assured that the repair will be handled by trained
service technicians who have the original replacement
parts for your appliance.
/
E-Nr.
FD-Nr.
Customer Service
O
USA
877 442 4436
toll-free
CANADA
800 828 9165