Gaggenau VG 295 CA Installation Instructions Manual - page 9
9
Conversion to another type of gas
This gas stovetop corresponds to the categories
specified on the rating plate. By changing nozzles, it
is possible to convert the appliance to any of the
gases listed on the plate. The conversion kit can be
obtained from our customer service. With some
models, the conversion kit is included in the scope of
delivery.
Only a licensed specialist is authorized to switch the
appliance to another gas type.
Before carrying out the conversion, turn off the
electricity and gas supply.
Changing the low burn nozzle
1
Remove pan supports and all burner parts.
2
Remove control knobs. Unscrew fastening screws
(three 7 mm nuts on each burner and two Torx
T20 on the wok burner) and and carefully detach
stovetop.
3
The low burn nozzles are located in the gas valve
and are screwed in from above. Turn the black
plastic part so that the recess is above the nozzle.
Screw out nozzle and take nozzle out with small
pliers.
4
Insert the new nozzles as specified in the nozzle
table. The nozzles must be screwed in fully.
Changing the full burn nozzle: normal and large
burner
1
Detach the securing clips from the burner pipes.
Unscrew the burners and extract the burner
pipes. The electrode can be left connected.
Extract the burners from the burner pipes.
2
Extract the nozzles from the burner pipes by hand
and extract the O-ring.
3
Check correct fitting of the O-ring in the new
main nozzles. Slide the nozzles onto the burner
pipes. Do not bend the burner pipes!
4
Fit the burners onto the burner pipes. Fit the
burners. Screw down the burners.
5
After loosening the screw, adjust the outer
burner's air regulation sleeve to the correct
dimensions (see nozzle table - L1). Tighten the
screw again.
6
By turning or moving it, adjust the inner burner's
air regulation sleeve to the correct dimension
(see nozzle table - L2).
/
23(1
PP
PP
/