Gallagher T10 Installation Note - page 4

4   |  Part Number: 3E2453 R1

Installation Note  |  Gallagher T10 Mifare Reader

Using the drill template at the back of this installation note as a 

1. 

guide, drill all three holes.  Drill the 13mm (1/2 inch) diameter centre 

hole (this is the centre hole for which the building cable will exit the 

mounting surface) and the two fixing holes.

Run the building cabling out through the centre hole and through the 

2. 

reader base.

Secure the base to the mounting surface using the two fixing screws 

3. 

provided.  It is important the base of the reader is flush with and tight 

against the mounting surface.

Note:  Ensure the centre hole allows the cable to run freely out through 

the mounting surface, so that the reader facia can clip into the base.

Base

6 Gauge screw

Building cable

6 Gauge screw

Connect the reader tail extending from the facia assembly to the 

4. 

building cable.  Connect the wires shown below.

Note:  Do not cut the ‘Reserved’ wires, they may be required later.

Positive

Red

Negative

Black

Reserved

Orange

Reserved

Green

Reserved

Brown

CDXIV TX

White

CDXIV RX

Blue

Cardax IV Reader

Fit the facia assembly into the base by clipping the small lip, into the 

5. 

top of the base and holding the top, press the bottom of the facia 

assembly down into the base.