Gallagher T10 Installation Note - Connections

Part Number: 3E2453 R1  |  

5   

Installation Note  |  Gallagher T10 Mifare Reader

Insert the M3 Torx Post Security screw (using a T10 Torx Post Security 

6. 

screwdriver) through the hole at the bottom of the base to secure the 

facia assembly.  

Note:  The recommended torque for the security screw is 0.7Nm 

(0.5 lb/ft).  It is important not to exceed the maximum torque of 

1.5Nm (1.1 lb/ft).

Fit screw to secure facia to base

Facia

Building 

cable

Reader 

tail

Connection

Removal of the facia assembly is a simple reversal of these steps.

7. 

Connections

A Gallagher T10 Mifare reader can connect to one of the following devices 

using the “Cardax IV Reader” communications protocol:

Cardax FT Reader Module (for the Controller 6000)

•

Cardax FT GBUS Universal Reader Interface (Cardax FT GBUS URI)

•

Cardax FT Controller 3000-4R or 3000-8R

•

Cardax FT Universal Reader Interface (Cardax FT URI)

•

Cardax FT Reader I/O Interface

•