Game Ready 500055 User Manual - page 10
9
C O N T R O L U N I T S E T U P
Filling the Ice Box
Stand unit upright. Then unplug the unit from the electrical outlet. To open the ice box
lid, pull up on the latch on the end panel of the Control Unit. Fill the ice box with as much
ice as possible. For maximum cooling duration, use cubed ice. Pour water over the ice to
one-half inch below the rim.
Dry off the rubber gasket
to ensure a good seal. Close the
lid securely and lock it into place by pulling down on the latch.
Note:
The system provides cooling to the Wrap on less ice but we recommend you fill
the ice box completely.
Caution:
Do not pour hot water into the ice box.
Refilling the ice box:
Once the unit has been operating for more than an hour, check
the ice box. If little or no ice remains, then refill the ice box to assure maximum cooling.
If the unit is turned on its side, place it back in its upright position before opening the ice
box lid by pulling up on the latch. Press the power button to turn off the unit. Unplug the
unit from the AC adapter and empty excess water from ice box. Fill the ice box with as
much ice as possible. Pour water over the ice to one-half inch below the rim. Close the
lid securely and resume therapy.
Note:
Ice can be added to the Control Unit while it is running (as long as it is
standing upright).
Connecting the Wrap to the Control Unit
The connector snaps easily into place on the
end panel of the Control Unit. When inserted
correctly, the disconnect button will be on top.
To disconnect, simply press the button and
remove the connector from its port. When
disconnecting the Connector Hose from the
Control Unit, it is normal for a few drops of
water to drip from the Connector Hose nozzle.
Be sure not to hold the button down while
connecting the Wrap to the Control Unit.
Ice Box
Lid Supports
Latch
Disconnect
Button