Gardena AquaContour automatic 8133 Operating instructions manual - 8. Troubleshooting
17
GB
If the watering pattern is no longer even, the nozzles can be
cleaned using the cleaning needle provided.
The cleaning needle is located on the bottom of the housing.
1. Turn the cleaning needle
F
(e.g. with a coin) anticlockwise
through 180° and pull out
carefully (bayonet coupling).
2. Clean nozzles
G
with cleaning
needle
F
.
3. Refit cleaning needle
F
in
reverse order.
8. Troubleshooting
Fault Possible
cause
Remedy
Irrigation width smaller than
Dirt filter soiled.
v Clean dirt filter.
on initial start-up
Tap not opened sufficiently.
v Open tap further.
Water pressure too low.
v Increase water pressure /
water supply.
Batteries are flat.
v Replace batteries. If the
batteries are flat, the range
is reduced to the minimum
level.
Irrigation range is programmed
v Reprogramme irrigation
incorrectly.
range.
Watering pattern uneven
Nozzles soiled.
v Clean nozzles.
Nozzle head soiled.
v Clean nozzle head.
Nozzle head damaged.
v Contact GARDENA Service.
Watering pattern incorrect
Incorrect programme selected.
v Keep pressing Menu button
until the correct programme
is selected.
Large-Area Irrigation
v Re-install Large-Area
AquaContour automatic
Irrigation AquaContour
incorrectly positioned
automatic correctly on
by 180° on ground marker.
ground marker.
A
In the event of other faults please contact GARDENA Service.
Repairs should only be carried out by GARDENA service centres or dealers
authorised by GARDENA.
Clean nozzles :
G
F
F