Gardena EVC 1000 Operating Instructions Manual - 5. Operation
14
GB
2. Insert the two locking bolts
1
from outside through the holes
in the two central sections
2
of the upright and secure to the
lower sections of the upright
5
with two wing nuts
4
.
3. Screw the upper part of the upright with starting handle
3
to
the central sections of the upright
2
with two more locking
bolts
1
and the wing nuts
4
.
This completes the assembly of the hanle.
Warning : Fit the upper section of the upright with starting
handle
3
in such a way that the plug
7
with the power
cable
8
is on the right side (in direction of movement) (see
fig.).
4. Attach connection cable
8
to the handle with the two cable
clips
0
.
5. Operation
1. Push connector of extension cable
0
on to the plug
7
.
2. Draw a loop of the extension cable
0
through the cable strain
relief device
A
1
and suspend in position
2
.
This prevents inadvertent disconnection of the plug and socket
connection.
3. Insert extension cable
0
into a mains socket.
Danger of injury if the Aerator does not switch off automati-
cally !
V
Do not remove or bridge safety devices fitted to the Aera-
tor (e.g. by tying the starting lever to the upper handle) !
Danger ! The Aerator does not stop immediately after
A
the motor has been switched off :
V
Never lift, tip or carry the Aerator with the motor
running !
V
Never start on solid ground (e.g. asphalt).
V
Always maintain the safety distance between the
aerator cylinder and the user as defined by the
guide handle.
1. Place Aerator on flat grass surface.
2. Keep safety interlock
B
pressed down and pull starting lever
C
on the upper handle
3
.
The Aerator starts.
3. Release safety interlock
B
.
When in operation, the extension cable
0
must always be
guided in the direction you are working and to the side of
the area to be worked on.
Always work away from the connection cable.
3
9
6
5
1
2
4
0
8
7
Connect extension cable:
Starting Aerator :
0
A
7
1
2
3
B
C