Gardsman CTC-1052RV User Manual - page 12
9
z
(0), Contact ID, is set as factory default for
all
4
telephone Numbers.
N
N
O
O
T
T
E
E
>
>
)
The latest Command (20-24) setting(s)
will overwrite any previously entered
setting(s).
)
If any of Digital Reporting Methods
is selected:
Once alarm or emergency data is
successfully transmitted, CTC-1052RV
will automatically enter specific
Follow-On and/or Call Back Mode as
specified by Command (38).
)
If Speech Method is selected:
After the dialing for alarm/emergency
trigger is successful, CTC-1052RV
opens a two-way voice communication
between the Call Recipient and CTC-
1052RV for 1-10 minutes (set by
Command #46).
If the Call Recipient needs more talk
time, they can press any keys except
9 on their phone set to add another 1-
10 minutes (set by Command #46).
To terminate the call, press (9) or
RESET BUTTON on CTC-1052RV.
During the Speech period, CTC-
1052RV will emit two beeps via the
telephone handset to alert the call
recipient the remaining time of 20 & 10
secs.
During the Speech period, if there is
no any DTMF command pressed, the
call will automatically hang-up and be
recorded as an unsuccessful call. It
will retry up to a max. of 4 times on
each Tel. Number accordingly.
)
If any of SMS Reporting Methods is
selected:
CID sent over SMS is a backup path
when alarm can’t go through in digital
reporting method. Once alarm or
emergency data is successfully
transmitted, the CTC-1052RV will
automatically send out a SMS (CID)
Message.
Command 31
Ringer Enable for Incoming Calls
z
CTC-1052RV can be programmed to emit
a ring tone as an audio alert, or silent for
incoming calls.
Function Selection
Result
(0)
OFF
(Ring Tone Disable)
(1)
ON
(Ring Tone Enable)
z
Factory
Defaultis set as (0), OFF.
N
N
O
O
T
T
E
E
>
>
)
If the function is set to ON, you can
answer the incoming call by pressing
the RED HELP BUTTON or Pendant
Button.
)
The time-out period for the incoming
call is 30 minutes. During the
communication, CTC-1052RV will
emit two beeps via the telephone
handset to alert the call recipient the
remaining time of 20 & 10 secs.
)
Press any DTMF keys (except
DTMF#9) can extend another 30 min.
)
To terminate the incoming call: (1)
press the green reset button on CTC-
1052RV; or, (2) press DTMF #9 from
the call recipient’s end.
)
During the AC Power failure period,
Ring Tone is automatically disabled.
Command 32
Audible Fault Alert
z
CTC-1052RV can be programmed to emit
detected and existent Fault Alert Beeps at
every 30 secs.
Function Selection
Result
(0)
OFF
(No Warning Beep)
(1)
ON
(With Warning Beep)
z
Factory Defaultisset as (0), OFF.