Gardsman CTC-1052RV User Manual - 3.2. Programming Your 1052
6
3.1.2. CTC-835 Programmer
CTC-835 is a powerful programming tool (sold
separetely) that features a built-in keypad and
LCD display to help you to program the
medical alarm panels effeciently and
conveniently. It also features Once-for-All
Uploading, which allows you program on a
computer via the supplied Pilot software and
you can then upload all the settings to the
medical alarm panel simultaneously with a
single mouse click.
For detailed usages, please refer to the
Operation Manual of CTC-835 Programmer.
3.1.3. SMS Remote Programming
CTC-1052RV can be remotely programmed via
SMS commands. Please refer to section 3.3
SMS Remote Programming for usage.
3.2. Programming Your 1052
z
How to enter Commands?
Please make sure CTC-1052RV is in
Programming Mode (RED LED flashes
continuously) before trying any CTC-
1052RV Command Functions. Please refer
to section System Configuration, Entering
Programming Mode.
z
Follow the protocol below to command
CTC-1052RV:
CC # DTMF
ACK
Function
Selection
# DTMF
ACK
1. 2. 3.
4.
5.
6.
1. CC = 2-digit DTMF Command
2. # =Termination of the DTMF Command
3. ACK = DTMF Command
Acknowledgement
On CTC-1052RV:
Short beep: Command succeeded
Long beep: Command failed
On the programming phone set:
Short beep: Command succeeded
Long beep: Command failed
4. Function Selection = According to
different Command you will have different
entering in this part, e.g. Tel. Number,
Account number, etc.
5. # = Terminates Function Selection
6. ACK = Function Selection
Acknowledgement
On CTC-1052RV:
Short beep: Command succeeded
Long beep: Command failed
On the programming phone set:
Short beep: Command succeeded
Long beep: Command failed
z
Follow the Command Steps to program
your CTC-1052RV:
Step 1. Enter Command number (DTMF
Numeric Command, ex. (01), (02)…)
Step 2. Press (#) to terminate the DTMF
Command.
Step 3. One short beep will be heard for
successful Command entry.
Step 4. Enter the desired Command function
number.
Step 5. Enter (#) to terminate the Command
Operation.
Step 6. CTC-1052RV will emit a short beep,
indicating successful programming.
The maximum interval between key strokes is
2 minutes. Otherwise, commands will be
ignored and CTC-1052RV will automatically
exit to Idle Mode.
z
Any erroneous programming must be
rectified and program again correctly.