Gardsman IC2020 User Manual - page 13
10
z
Factory Default for Alarm Reporting is set
as (1), 1
st
Tel. #.
z
Factory Default for Status Reporting is set
as (2), 2
nd
Tel. #.
<
<
N
N
O
O
T
T
E
E
>
>
)
The Tel. number selected in
Command #7 will not be used for
alarm and/or status reporting, even if it
is selected in command #5 and/or #6.
)
When multiple Tel. numbers are
selected, the IC2020 will always dial in
respective programmed order.
)
The latest Command (05-06) setting(s)
will overwrite any previously enter
setting(s).
Command 07
Select Telephone Number for Nurse call
z
This command is used to select which
telephone number will be used for Nurse
call.
z
The selected Tel. number will not be used
for alarm and/or status reporting, even if it
is selected in command #5 and/or #6.
z
Available key-in options:
Tel. Number
Function Selection
Sequence
Disable
(0)
1
st
Tel. #
(1)
2
nd
Tel. #
(2)
3
rd
Tel. #
(3)
4
th
Tel. #
(4)
z
Factory default is set as (3), 3
rd
Tel. #.
Alarm will be reported to 1
st
Tel. number,
and Status will be reported to 2
nd
Tel.
number.
z
Please refer to section 4.1.2 for more
information.
Command 08
Retry Method
z
This command is to program the preferred
sequenced/method used for reporting.
z
Available key-in options:
Retry Method
Function Selection
Alternative
(0)
On-by-One
(1)
z
Factory default is set as (0), Alternative.
<
<
N
N
O
O
T
T
E
E
>
>
)
If the Alternative method is chosen,
the system will try reporting sequence
in cycle of each Tel. number. A max of
5 cycles will be tried.
TEL#1
ÆTEL#2ÆTEL#3ÆTEL#4…
and repeat for 5 cycles.
)
If One by one method is chosen, the
system will try each Tel. number to a
max of 5 times before moving onto the
next priority.
TEL #1 1
st
time
Æ…ÆTEL #1 5
th
time
TEL #2 1
st
time
Æ…ÆTEL #2 5
th
time
TEL #3 1
st
time
Æ…ÆTEL #3 5
th
time
TEL #4 1
st
time
Æ…ÆTEL #4 5
th
time
Command 10-14
Account Number Programming
z
Commands (10-14) are used to set the
account number for the telephone numbers
used for Digital Reporting.
z
Command (10): Set the same account
number for all telephone numbers.
z
Command (11-14): Set the account
numbers for the 1
st
-4
th
Tel. numbers used
for Digital Reporting respectively.
z
In (Function Selection) key in 4 or 6 digit
Account Number.
z
Global
account number is pre-
programmed when shipped for all 4 Tel.
numbers. Each unit possesses a unique
account number.
z
When the unit is reset to factory default,
this pre-programmed account number will