Gardsman IC2020 User Manual - page 23
20
Commands 93
Learn-In Silent Pendant
z
Only one Silent Pendant can be learnt into
IC2020 by using Command #93.
z
For learning Silent Pendant :
Step 1: Enter 93 + # on the phone set, then
a short beep will be heard via the
phone set.
Step 2: Press the Pendant Button within 20
sec.
)
Learning can only be completed
within the signal reception range of
IC2020.
)
If no signal is received within 20
sec, IC2020 will emit a long beep
and automatically returns to
Programming mode.
Step 3: IC2020 will emit 2 beeps to indicate
the Silent Pendant is learnt-in
successfully.
)
Adding a Pendant for a second
time is prohibited unless it is
removed from the system first.
)
If one long beep is emitted
instead of 2 beeps, this indicates:
9
The device has already been
learnt-in.
9
Another device has been learnt-
in before.
<
<
N
N
O
O
T
T
E
E
>
>
)
When IC2020 received the alarm
signal from the Silent Pendant, it will
not sound any warning beeps during
Reporting and Guard Time period.
Commands 94
Learn-In Device
z
Up to 7 devices can be learnt into IC2020
by using Command #94.
z
The available devices that can be learnt-in
Command #94 are:
9
PIR Sensor ----- PIR
9
Smoke Detector ---- SD
9
Carbon Monoxide ---- CO
9
Fixed Panic Button ---- PB
9
Wrist Transmitter ---- WTR
9
Pendant Transmitter ---- WTR
9
Water Sensor ---- WS
9
Remote --- IC2020TX
Step 1: Enter 94 + # on the phone set, then
a short beep will be heard via the
phone set.
Step 2:
Press the learn button on the
device within 20 sec. For Remote
Controller, press either the Red or
the Green button.
)
Learning can only be completed
within the signal reception range of
IC2020.
)
If no signal is received within 20
sec, IC2020 will emit a long beep
and automatically returns to
Programming mode.
Step 3: IC2020 will emit 2 beeps to indicate
the device is learnt-in successfully.
)
Adding a Pendant for a second
time is prohibited unless it is
removed from the system first.
)
If one long beep is emitted
instead of 2 beeps, this indicates:
9
The device has already been
learnt-in.
9
When an 8
th
device is attempted
to learn-in.
Step 4: Repeat Steps 1-3 until all devices
are learnt-in.
<
<
N
N
O
O
T
T
E
E
>
>
)
Adding a device for a second time is
prohibited unless it is removed from
the system first.
Command 98
Factory Default Reset
z
To Reset IC2020 to factory default settings,
enter (98) and then (#).
z
After one short beep, continue by entering
(
ÀÀ) and then ending with another (#),
one beep will sound for termination.
z
Once the Factory Default Reset is
executed, all the programmed data is
returned to its default value and all the
devices that have been learnt-in are
removed. You have to do the programming
and learn-in the device one by one again.