Gardsman IC2020 User Manual - 4.3. Walk Test (Range Test)
26
accordingly.
Speech Reporting Method
z If Speech Reporting Method is selected,
after dialing, IC2020 will open a two-way
voice communication between the Call
Recipient and IC2020 for 1-60 minutes
(set by Command #46).
z At 20 & 10 seconds before the time period
expires, IC2020 will emit two beeps via the
telephone handset to alert the user.
z If the Call Recipient needs more talk time,
s/he can press any keys except 9 on their
phone set to add another 1-30 minutes
(set by Command 46).
z To terminate the call, press either (DTMF
9)or NURSE button on IC2020.
z During the Speech period, if there is no
any DTMF command pressed, the call will
automatically hang-up and be recorded as
an unsuccessful call. It will retry up to a
max of 4 times on each Tel. Number
accordingly.
Call Sequence
The call sequence is followed by Tel.
#1, Tel. #2, Tel. #3 to Tel. #4. It is
recommended to set digital reporting
method in first priority for immediate
help.
If either Digital Alarm reporting OR
Speech Alarm reporting is set, with
anyone answered successfully, the
call sequence will be terminated
automatically.
If more than one reporting methods
are set, the reporting call sequence
will
only be terminated once each
reporting method is answered
successfully.
There is a calling pause between
each call. For different Tel. Numbers
the pause is set as 5 sec, and for
same Tel. Number, it is set as 62 sec.
Retry Method
Retry Circle: Each Tel. Phone number can
be retried up to 5 times alternative; and
max. 15 calls will be retried. During the
retry period, the Red LED still stays on
steadily, while the Red Emergency Button
backlight dims.
In the retry circle, if any digital, voice
message, or speech reporting fails, IC2020
makes a 10-min pause, then starts another
15-call retry circle, followed by another 10-
min pause. This cycle repeats until all
reporting is/are answered successfully.
During the 10-min pause, IC2020 returns to
normal mode with Red LED on:
Press the White Nurse button to
terminate the reporting.
If new event happens, IC2020 starts
the reporting immediately.
4.3. Walk Test (Range Test)
Put IC2020 in Learning Mode to determine the
operation range of the devices.
Step 1. From Idle mode, press and hold the
EMERGENCY & NURSE button for 6
seconds.
Step 2. Once pressed, a button beep sound
will be heard. IC2020 will emit 3 beeps
at 6 sec.
Step 3. Release the button after you heard
two short beeps. Then, IC2020 is now
in Learning Mode. The RED LED
begins to flash.
Step 4. Move the device to your desirable
location in the house, and press the
TEST button to observe the range for
its operation.
Step 5. If IC2020 responds with one long
beep, then the particular device is
within the operation range.
Step 6. To exit Learning Mode, press both
NURSE & EMERGENCY buttons
simultaneously.
Or, if no signal is received within 30
sec, IC2020 will exit Learning mode.