Garland MULE 341 G Instruction Manual - page 26
English
26/84
English
27/84
Never remove the cap of the fuel tank while the
engine is running or when the machine is hot.
Do not refuel in enclosed spaces, in poorly ventilated
areas or near flames.
Make sure the cap of the fuel is tightly and correctly
closed while you are using the machine.
Make sure to correctly and tightly close the cap on the
fuel after refilling.
Almacene siempre el combustible en recipientes
homologados que cumplan con la normativa europea.
Do not use fuel that it has been stored for longer than
2 months. A fuel that has been stored for too long will
cause the starting of the machine to be more difficult
and unsatisfactory engine performance. If the fuel has
been in the tank of the machine for more than two
months, take it out of the machine and replace it with
one in perfect condition.
2.5. CARE AND USE OF THIS MACHINE
Use this machine only to till the land. Do not
use this rotary tiller for other purpose not intended.
The use of this rotary tiller for uses other than the
designated operations may result in dangerous
situations.
Use this machines’ accessories, tools, etc. in
accordance with these instructions and as intended,
taking into account the working conditions and the
work to develop. The use of this rotary tiller for uses
other than the designated operations may result in
dangerous situations.
Check that all the safety devices are installed and in
good condition.
Remember that the machine operator is responsible
for the dangers and accidents caused to other people
or things. The manufacturer will not be in any way
liable for damages caused by improper or incorrect
use of this machine.
The cutting tool is very sharp. Not following the
instructions may cause severe damage.
Keep your body away from the cutting tool while using
the machine.
Do not force this machine. Use this machine to the
correct application. Using the machine for the type of
work meant to be done will allow you to work better
and more safely.
Do not use this machine if the switch does not change
between “open” and “closed”. Any machine that
cannot be controlled with the switch is dangerous and
must be repaired.
Before starting work with the machine, check that the
milling cutters are not in contact with any object and
that they can move freely.
Do not use the machine on steep slopes where your
safety cannot be guaranteed. If you are working on
slopes slow down your work pace and ensure you
have a good stability.
Keep this machine maintained and in proper condition.
Check that the moving parts are not misaligned
or locked, that there are no broken parts or other
conditions that may affect the operation of this
machine. Whenever this machine is damaged, repair
it before use. Many accidents are caused by poorly
maintained machines.