Garland MULE 341 G Instruction Manual - 6. Start Up Instructions
English
30/84
English
31/84
6. START UP INSTRUCTIONS
6.1. UNPACKING AND LIST OF MATERIALS
This machine includes the following items that you will
find inside the box:
• Machinewithmillingcutters.
• Tophandlebar.
• Fixingscrewsoftophandlebar(x4)
• Fixingwingnutsoftophandlebar(x4)
• Fixingwashersoftophandlebar(x4)
• Bottomhandlebar.
• Fixingscrewsofbottomhandlebar(x2)
• Fixingnutsofbottomhandlebar(x2)
• Cablepins(x4)
• Spur
• Holdingbobbypinandcirclipofthespurholder.
• Instructionmanual.
6.2. ASSEMBLY
6.2.1. MOUNTING THE BOTTOM HANDLEBAR
1. Place the bottom handlebar (A) in the grooves that
exist between the engine (B) and the protector (C).
2. Place two cable pins (D) in the screws (F).
3. Insert the screws (F) through the right side of the
machine through the holes of the bottom handle.
4. Place two cable pins (D) in the screws on the left
side.
5. Place the nuts on the screws
(F).
6. Place the on/off cable on the left side of the
machine holding the cable using the cable pins (D).
7. Place the accelerating cable on the right side of the
machine holding the cable using the cable pins (D).
8. Tighten the screws.
6.2.2. MOUNTING THE TOP HANDLEBAR
Install the top handlebar (A) inserting the screws (B)
with the washers (C) and tighten the knobs (d) tightly.
6.2.3. INSTALLING THE SPUR
1. Place the spur (a) at the desired height.
2. Insert the pin (b).
3. Fix the pin with the circlip (c).
D
A
C
B
A
B
C
E
E
B
A
F
D
C
D
F