Garland MULE 341 G Instruction Manual - 8. Maintenance and Service
English
34/84
English
35/84
Secondary tillage is less shallow than the principal,
making 2 cross-styled passes on the terrain is
enough.
8. MAINTENANCE AND SERVICE
Removing the security devices, improper maintenance,
or replacements with non-original spare parts can
cause injury.
Do not change the control mechanisms of the
machine or the speed limitations of the engine to try
and increase the rotation regime.
The object of the maintenance and service is to
ensure that the machine always works in the best
possible conditions of both security and efficiency.
Follow the recommendations and maintenance
periods of this manual.
Before performing any maintenance or repair on the
machine make sure that the engine has stopped and
remove the spark plug pipe.
WARNING! Do not modify the machine or cutters.
Improper use of these elements can cause SERIOUS
PERSONAL DAMAGE OR DEATH.
Keep the machine clean, especially the area of the
fuel tank and areas close to the air filter. To reduce fire
risks, maintain the engine, the muffler and the area
around the petrol deposit clean, without any debris or
grease.
Only perform machine maintenance with the machine
on a flat, cleared surface.
Use only suitable replacement for this machine in
order to obtain a proper performance of the machine.
This replacement can be found in the official
distributors of the machine. The use of other spare
parts can cause risks, damage to the user, people
around and the machine.
Do not adjust the carburetor. If necessary, take
your machine in for service. Carburetor adjustment
is complicated, and only the technical maintenance
service must do them. Incorrectly setting the carburetor
may cause damage to the engine and will be cause for
cancellation of the warranty.
8.1. MAINTENANCE AND CARE AFTER USE
Perform the following maintenance operations
and care when you have finished working with
the machine to ensure the smooth running of this
machine in the future.
8.1.1. GENERAL CHECKPOINTS
Make sure the milling cutters are securely attached
to the transmission. If necessary, tighten the milling
cutters.
Check the edge of the cutter and state of the milling
cutters. Replace the milling cutters when necessary. It
is recommended that these operations are carried out
by an authorized service technician.
8.1.2. CLEANING THE MILLING CUTTER AND THE
MACHINE
Attention! Always clean the machine after use.
Not cleaning the machine adequately can cause
damages to the machine and cause the machine
not to work properly.
Attention! The tills are sharp and can cause
damages. Use protecting working gloves when
cleaning the machine.