Garmin Dash Cam 10 Owner's Manual - page 10
2
Plug the larger end of the USB cable into a
port on your computer.
3
On the device, select OK.
A picture of your device connected to a
computer appears on the device screen.
Depending on your computer operating
system, the device appears as either a
removable drive or a removable volume.
Changing the Fuse in the Vehicle Power
Cable
NOTICE
When replacing the fuse, do not lose any of the
small pieces and make sure they are put back in
the proper position. The vehicle power cable
does not work unless it is assembled correctly.
If your device does not charge in your vehicle,
you may need to replace the fuse located at the
tip of the vehicle adapter.
1
Unscrew the end piece
À
.
TIP: You may need to use a coin to remove
the end piece.
2
Remove the end piece, the silver tip
Á
, and
the fuse
.
3
Install a 2 A fast-blow fuse.
4
Place the silver tip in the end piece.
5
Screw the end piece back into the vehicle
power cable
Ã
.
Resetting the Device
You can reset your device if it stops functioning.
Hold the power key for 10 seconds.
10