Garmin GPS 10 Deluxe Application Manual - page 44
38
Garmin Que Applications Guide
A
DDITIONAL
I
NFORMATION
>
Troubleshooting Guide
Symptom Probable Cause Remedy
GPS Signal Related Problems
“No GPS Connected” message
GPS receiver is not turned on.
Turn On receiver.
GPS receiver is not powered.
Connect power source or charge battery.
GPS receiver (if wireless) is out of range.
Relocate.
GPS receiver (if wireless) is not paired.
See GPS receiver setup instructions.
“Waiting for GPS” message stays on
GPS receiver is not powering up
Battery low, check battery charge.
“Acquiring Satellites” message stays on
GPS receiver is collecting satellite data.
Wait for data to be collected.
“Lost Satellite Reception” message appears
GPS receiver cannot maintain a constant signal
Move to location with less interference
repeatedly
Antenna is incorrectly positioned
Relocate antenna for best reception
Cannot achieve reliable satellite signals when
Some auto windshields are tinted using a thin
Most vehicles with this type windshield
the GPS receiver is mounted on my auto dash. metallic coating to reflect ultraviolet sun rays.
block satellite signals as well. GPS
receivers will not operate inside the vehicle.
With the receiver on my auto dash, the satellite Car radios and CD players can generate electrical Relocate the GPS receiver away from the
signal reception is weak.
fields that can interfere with satellite signals
radio or turn off the radio when using the
Garmin Que to navigate
Map Messages at Startup or Card Insertion
“Can’t Unlock Maps”
You must enter the unlock code during MapSource
Follow installation instructions on the setup
installation
Disk
“Detailed Maps Don’t Support Routing”
These maps are not the type used for auto-routing Select maps designed for auto-routing.
“Too Many Maps on Data Card”
The map sets you are trying to load are too
Check the space available in the chosen
large for the space available in the storage location location and choose another location with
enough space or reduce the map set size
Map Data Related Problems
No Find Feature items listed for “By Name”
Maps that support that option are not installed
Open MapSource and select maps from
options
from MapSource
City Select version 6.5, then save to Garmin
Que
“None Found” message when accessing the
These options only display data from topographic Load maps of this type using MapSource
Man made Places, Water Features, and Land
maps and marine charts
topographic and marine chart map data
Features Find Options
Find Feature Search Messages
“Select Street Before Searching”
You have tapped the “Search” button before
Enter a street name before beginning your
entering the name of the street for an address
search for an address
“Select Two Streets Before Searching”
You have entered none or only one street before
Enter both street names to complete the
searching for an intersection
intersection description
“None Found”
This message appears when there is no data
Try entering a variation of the item description
in the loaded maps matching the entry
If you encounter operational problems that you cannot solve using this guide, first determine that they are not related to operation of your Pocket PC, then:
Contact Garmin Product Support at 913/397.8200 or 800/800.1020