Garmin GPSMAP 1000 Series Owner's Manual - Customizing Your Device
4
Select the remote, and select
Add
.
After the remote is paired, it connects to your device whenever
the device is in range and turned on.
Customizing the Action Key
1
From the Edge home screen, select >
Sensors
>
Edge
Remote
>
Sensor Details
.
2
Select
Single Press
or
Press and Hold
.
3
Select a function for the action key.
For example, you can set the action key to display the map or
turn on the backlight.
Using the Mounts
Several mounts are available for your remote, either included
with the product or as an optional accessory. The mounts allow
you to attach the remote to your body, your bike, or other
objects.
• Align two of the notches
À
with the sides of the mount, and
press the remote into the mount until it clicks.
• Press gently on the release tab
Á
, and lift the remote from
the mount.
Replacing the Battery
WARNING
Do not use a sharp object to remove batteries.
Keep the battery away from children.
Never put batteries in mouth. If swallowed, contact your
physician or local poison control center.
Replaceable coin cell batteries may contain perchlorate
material. Special handling may apply. See
CAUTION
Contact your local waste disposal department to properly
recycle the batteries.
Before you can replace the battery, you must have a small
Phillips screwdriver, a small flat screwdriver, and a CR2032
lithium coin-cell battery.
1
Using a Phillips screwdriver, remove the three screws from
the back plate
À
.
2
Remove the back plate from the remote.
3
Wrap the end of a small flat screwdriver with tape.
The tape protects the battery, battery compartment, and
contacts from damage.
4
Carefully pry the battery from the back plate.
5
Install the new battery into the back plate with the positive
side facing down.
6
Verify the gasket
Á
is fully seated in the groove.
7
Replace the backplate, aligning the post
with the gap in the
circuit board
Ã
.
8
Replace and tighten the three screws.
NOTE:
Do not overtighten.
Customizing Your Device
Setting Up Your User Profile
You can update your gender, age, weight, height, and lifetime
athlete settings. The device uses this information to calculate
accurate ride data.
1
Select >
User Profile
.
2
Select an option.
About Lifetime Athletes
A lifetime athlete is an individual who has trained intensely for
many years (with the exception of minor injuries) and has a
resting heart rate of 60 beats per minute (bpm) or less.
Training Zones
• Heart rate zones (
)
• Power zones (
)
Setting Your Heart Rate Zones
The device uses your user profile information from the initial
setup to determine your heart rate zones. You can manually
adjust the heart rate zones according to your fitness goals
). For the most accurate calorie data
during your activity, you should set your maximum heart rate,
resting heart rate, and heart rate zones.
1
Select >
Training Zones
>
Heart Rate Zones
.
2
Enter your maximum and resting heart rate values.
The zone values update automatically, but you can also edit
each value manually.
3
Select
Based On:
.
4
Select an option:
• Select
BPM
to view and edit the zones in beats per
minute.
• Select
% Max.
to view and edit the zones as a percentage
of your maximum heart rate.
• Select
% HRR
to view and edit the zones as a percentage
of your resting heart rate.
Customizing Your Device
9