Garmin Streetpilot C320 Setup Manual

Step 1: Configure Your c320

Press and hold the 

Power 

button to turn 

on the unit. 

Note:

 A “Low Battery” 

warning may appear when 

you turn on the unit. Charge 

the unit for three hours.

1

2

Answer the configuration questions that appear. When you 

see the screen that states “To use this unit, map data must be 

installed,” you are ready to install software and map data. 

Start Here

Open this setup guide and follow the instructions to set up your c320. 

Complete all of the setup steps:

Step 1: Configure your c320

Step 2: Install software and map data

Step 3: Load maps

Do not connect the USB cable to your PC until you are instructed to do so. 

StreetPilot

®

 c320

This setup guide includes instructions to 

configure your c320 and load maps. 

To ensure a successful installation, follow 

the steps outlined in this guide. 

Do not 

connect the USB cable to your PC until you 

are instructed to do so. 

For information about using your c320, refer 

to the 

c320 Quick Reference Guide located in 

the box. Also see the 

c320 Owner’s Manual 

at www.garmin.com/products/sp320/.

se

tup guid

e

190-00435-02 Rev. C 

Volume control

Power button

USB cable connector