GOLDEN STATE INSTRUMENT CO GS-16CH264 User Manual - page 12
23
Item
Description
Key Tone
Enable/Disable Audible button presses for remote and panel
Buzzer
Enable/Disable buzzer operation when the alarm is triggered for
sensor, motion and vloss (Video Loss).
Relay
Enable/Disable the signal to be sent to the RELAY OUT blocks
when the alarm is triggered for sensor, motion and vloss.
1-8.4 SPOT SETUP
Main monitor output is enabled by default out of the BNC composite output and is
selectable to be a Spot Monitor output
Item
Description
SPOT MODE
Channels display in spot for two different modes:
Disable: The screen is same the main screen with VGA output,
Enable: Spot Mode
Interval (Seconds)
The duration time in seconds for the interval between channels
under SPOT mode.
Skip Video Loss Channel
Whether to skip channels without video signal.
24
1-9 UTILITY SETUP
Item
Description
HDD Initialization
Select to enter hard disk initialization menu. Please stop
recording before entering this menu. Enter the menu,
system will show all the data (model, volume) of HDD that
installed in DVR. Check the HDD you’d like to initialize
then press “Start”. HDD initialization is successful when
the status shows “Succeed”
USB Initialization
Clean up all data on USB. Enter USB initialization and
press YES to clean up all data on your USB. The
initialization is done when it’s showed “Succeed”.
System Recovery
Restore DVR to factory Defaults
Reset System Events
Reset the event list
Copy Setup to USB
Copy configuration to a USB device. There will be a file
named 「sdvr_conf.dat」 on your USB.
Download Setup from USB
Download configuration from a USB device into DVR.
Upgrade
Upgrade DVR through USB.
Please stop recording and backup setup configuration
before upgrading.
System will reboot automatically when the upgrade is
completed.
Notice! DO NOT TURN OFF POWER OR UNPLUG USB DEVICE DURING THE UPGRADE
as it may cause incomplete firmware upgrade and damage to the DVR.