Electric bake and pizza oven proudly australian made installation procedure – user manual service instruction models e-201, e-541 and multiples e-542 e-201 electrical approval cs 365 established 1911 the cooking equipment professionals www.Goldsteineswood.Com.Au.
Table of contents 1. Introduction page 3 2. Commissioning page 4 3. Installation page 5 4. Operating instructions page 6 5. Cleaning & servicing page 7 6. Wiring diagram e-201 page 8 7. Wiring diagram e-541 page 9 8. Drawings page 10 9. Spare parts page 11 10. Warranty page 12 11. Branches page 13 i...
1. Introduction congratulations for purchasing your goldstein commercial cooking appliance. J. Goldstein & co. Is a wholly owned australian company and has been operating since 1911, building high quality products. The information in this manual will assist your installer and ensure correct location...
2. Commissioning commissioning appliance – details, testing, checking pressure etc. Commissioning check list 1. Check for damage and missing parts on back of warranty card. 2. Remove all plastic coating from s/steel panels. 3. Make sure all parts are in their correct position e.G. Trays control knob...
3. Installation instructions installation of the oven a. Before assembly and connection 1. Check for damage, 2. Check crates for handling damage. After carefully uncrating, check for “concealed” damage. Report any damage immediately to carrier and to dealer. 3. Check electrical supply. B to assemble...
4. Operating instructions oven operation . 1. Always load the deck of the oven with pans spaced away from each side and the back of the oven to allow even distribution of heat. 2. The required temperature for the oven should be set on the thermostat and the simmerstat should be set at full for the h...
5. Cleaning & service instructions cleaning this is a most essential part of general maintenance and to ensure satisfactory operation of any appliance must be carried out at very regular intervals. The use of water on or near any electrical element or connection point must be avoided. At the most a ...
6 wiring diagram model e-201 2 banks or 4 elements im010b1/p8.
7 wiring diagram model e-541, 2 banks of 6 elements im010b1/p9.
8. Drawing model: e201, e202, e541, e542 im010b1/p10 o ff n o 12 11 13 9 5 1 1 3 14 10 6 8 7 3 4 2 1.
9. Spare parts model: e201, e202, e541, e542 item no. Code description 1. Mknplts4 knob – energy regulator 2. Msi00001 simmerstat – radiant (new type) 3. Esw00007 switch – main. With silicone boot 4. Minkb013 insulation – kiln batts bea/beb 5. Mkn00004 black knob 6. Etck0000 old type “k” thermocoupl...
10. Warranty installation must be carried out according to local regulations by qualified trade persons. Isolating switch(es), shut-off valves etc must be within easy reach of the machine for future service and maintenance requirements. If in doubt call goldstein/eswood or their representative for f...
11. J goldstein & co pty ltd branches for inquiries please call your nearest state branch: head office 211-213 woodpark road new south wales 2564 phone: 02 9604 7333 fax: 02 9604 5420 victoria queensland unit 13 unit 3 260-264 wickham road 49 logan road moorabbin woolloongabba victoria 3189 queensla...
