Goldstein E201 Installation procedures manual - page 7
5. CLEANING & SERVICE INSTRUCTIONS
CLEANING
This is a most essential part of general maintenance and to ensure satisfactory
operation of any appliance must be carried out at very regular intervals. The use of
water on or near any electrical element or connection point must be avoided. At the
most a damp cloth may be used after excess grease has been removed with a
degreaser, NOT CAUSTIC SODA.
Daily cleaning of your appliance will be amply repaid in longer life and more efficient
operation.
To maintain the lustrous finish of the stainless steel, regular cleaning with soap and
water is usually all you need. Just wipe surface with damp cloth or soft leather, using
scrubbing brush. If necessary, for corners or crevices. Dry the steel and polish with
a leather or soft dry cloth.
NEVER USE ORDINARY STEEL WOOL, any metallic scouring
materials or harsh abrasives.
PLEASE NOTE: Always clean oven when it is COLD.
SERVICE INSTRUCTIONS
Disconnect from mains supply by removing fuses or turning off circuit breaker. The
controls and wiring are readily accessible after the lower stainless steel fascia plate is
removed. Care must be taken with this panel as all the wiring and thermostats are
attached.
IM010B1/p7