Good Energies B-CURE LLLT-808 Operating Instructions Manual - page 24
8. Instructions for Best Results
Coverage of the treated area:
■
if the area requiring treatment is larger than 1x4.5 cm, repeat treatment on the
area adjacent to the previously treated area, until the entire area is covered (see illustration in page 19).
Hold the
device onto the treated area without moving it.
After covering an area of 4.5 cm² (the laser beam’s width),
for the recommended time, (4-8 minutes, depending on the treatment), move the beam to the adjacent area.
This will ensure that each area in need of treatment will receive optimal care.
Do not treat wide areas with
circular motions.
Treatment may be up to 4 times daily.
■
Immediately after a burn or an injury-even 10 consecutive treatments! We
would like to remind you that overdose does not cause any harm.
First treatment: always start the treatment for chronic pain and ailment for only 1.5 minutes.
■
If pain worsens
after a first treatment, it means the bio-stimulation is in action. We recommend you discontinue the treatment
for 24 hours. Afterwards treat again for 1.5 minutes, until the pain does not worsen. Continue the treatment by
slowly increasing the dosage until you reach the recommended dosage, and according to your personal feeling.
When treating internal problems,
■
such as back and thigh pain or inflammation, we recommend operating the
device by pressing it directly onto the skin (No. 5), and not by pressing the treatment start button.
B-CURE
®
LASER LLLT-808
|
24