I h3c wa2612-agn wlan access point installation manual.
Ii table of contents 1 product overview ...................................................................................................... 1 introduction ............................................................................................................ 1 hardware specifications ..........
1 1 product overview introduction the h3c wa2612-agn is an 802.11n access point (ap) product developed by h3c. The wa2612-agn ships as a fit ap (managed) and operate with wireless local area network (wlan) switches or access controllers to provide wireless access for wlan users. Hardware specificati...
2 led color state description link led) blinking slowly the wireless link is working normally blinking rapidly data is being transmitted or received. Interfaces the wa2612-agn provides a console interface and an ethernet interface. Note: the wa2612-agn provides a reset button and a security slot. De...
3 3 installing the ap note: 1) make sure that no metal particles (such as screws) fall into the ethernet or console interfaces during installation. 2) before installing the wa2612-agn to the wall-mounting bracket, connect the network cable. The network cable can only be utp cat-5. 3) before connecti...
4 there are five mounting holes in total in the wall-mounting bracket of the wa2612-agn. Select the three round holes (with a diameter of 5 mm, or 0.20 in) for the installation. Figure1 mounting hole pattern of, the wa2612-agn wall-mounting bracket: step2 insert the pointed end of wall anchors into ...
5 step1 adjust the position of the wall-mounting bracket and tighten the screws. Note: install the wall-mounting bracket with the arrow on the bracket pointing upwards. Installing the ap on the wall-mounting bracket step1 align the ap with the key-hole clips on the wall-mounting bracket and hang the...
6 note: the lock is user supplied. Mounting the ap on a ceiling note: 1) to use this installation method, make sure that the thickness of the ceiling is less than 18 mm (0.71 in), and the ceiling can bear the weight of at least 5 kg (11.02 lb.). 2) you are not recommended to use this method to mount...
7 figure6 mount the wall-mounting bracket on the ceiling (1) bolt inside the ceiling (2) washer (3) nut (4) wall-mounting bracket (5) bolt cap (6) key-hole clip step3 mount the wa2612-agn to the wall-mounting bracket. For details, refer to installing the ap on the wall-mounting bracket. Mounting the...
8 figure7 t-rail holder (1) t-rail clip (2) m4×8 screw nut (3) m3×6 screw nut (4) clip holder (5) m4×8 screw (6) m3×6 screw (7) mounting hook (8) t-rail holder (9) before installing to the t-rail, loosen the screw nuts until the screw heads are lower than the upper edge of the nuts. Step3 tighten th...
9 figure8 mount the ap to the t-rail (1) m3×6 screw (2) t-rail (3) mounting hook (4) t-rail holder (5) mounting clip (6) wall-mounting bracket (7) screw hole (8) m4×8 screw (9) key-hole clip (10) m4×8 screw power supply by poe power is supplied to the wa2612-agn through a poe module or poe switch. C...
10 approved channels use of this product is only authorized for the channels approved by each country. For proper installation, select your country from the country-selection list. To conform to fcc and other country restrictions, your product may be limited in the channels that are available. If ot...
11 este produto está homologado pela anatel, de acordo com os procedimentos regulamentados pela resolução 242/2000 e atende aos requisitos técnicos aplicados. Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência prejudicial, mesmo de estações do mesmo...