H3C WA2612-AGN Installation Manual - page 7
5
Step1 Adjust the position of the wall-mounting bracket and tighten the screws.
Note: Install the wall-mounting bracket with the arrow on the bracket pointing
upwards.
Installing the AP on the wall-mounting bracket
Step1 Align the AP with the key-hole clips on the wall-mounting bracket and hang
the AP on the bracket. See callout 1 in Figure3.
Step2 Press or rotate the AP to fix it. See callout 2 in Figure3. Fix the -shaped holes
on the AP’s rear panel to the key-hole clips on the wall-mounting bracket.
Figure3 Fix the WA2612-AGN onto the wall-mounting bracket
Note: Rotating the WA2612-AGN clockwise installs the device, while rotating it
counterclockwise uninstalls it.
Locking the AP onto the wall-mounting bracket (optional)
The WA2612-AGN has a security slot on the upper left side, which can be used to lock
the AP to a fixed object to prevent theft. Follow these steps to lock the AP to a fixed
object:
Step1 Fix the security cable to a nearby fixed object.
Step2 Insert the locking plate in the security slot to lock the AP.
Figure4 Lock the WA2612-AGN to a fixed object
(2)
(3)
(1)
Before installing the security lock:
(1) Security slot
After installing the security lock :
(2) Security lock
(3) Security cable