Holland Grill APEX BH421-SS5LPB Instruction Manual - page 7
A-4
Step 3.
Refer to Figure 2. Select the following items:
1. grill bottom assembly
2. lid stops
3. hinges
Select one of the lid stops. Insert the end of the lid stop with the
slot in it into the slot in the body bottom end panel. Insert a
T-Nut through slot in lid stop. Insert 10-24 Phillips screw with lock
washer into the hole in the bottom end panel and screw it into the
T-Nut. Tighten completely. Repeat for opposite side.
Bolt the 2 hinges to the grill bottom assembly using the 1/4-20 x
5/8 hex head bolts and lock washers. Do not fully tighten the
hinges at this time.
Step 4.
For use with BHA3013 only.
Refer to Figure 3. Select the following items:
1. grill bottom assembly
2. side brackets
Attach side brackets to grill bottom assembly using 1/4-20 X 5/8
hex bolts and lock washers at this time. Tighten fully. Note that
there is a right and left bracket.
Step 5.
For use with BHA3802 Trim Kit.
Refer to Figure 4a. Select the following items:
1. grill bottom assembly
2. side brackets
3. rear filler
Attach side brackets to grill bottom assembly using 1/4-20 X 5/8
hex bolts and lock washers finger tight in the 2 rear holes only at
this time. Attach the rear filler to the side brackets as shown
using 1/4-20 X 5/8 hex bolts, lock washers and nuts. Finger tight
only at this time.
Step 6.
Refer to Figure 4b. Select the following items:
1. grill body assembly
2. Front Panel
3. Control knobs
Select the front panel and place it into position as shown. Note:
The front panel mount flanges go on the outside of the side
brackets. Attach front panel to grill bottom assembly using 1/4-20
X 5/8 hex bolts and lock washers in the 2 front holes at this time.
Now fully tighten all bolts from Steps 5 and 6.
❍
❍
❍
❍
❍
FIGURE 3
For use with BHA3013 only.
FIGURE 4a
For use with BHA3802 Trim Kit.