Holland Grill APEX BH421-SS5LPB Instruction Manual - page 9
A-6
Step 9.
Refer to Figure 6b. Select the following items:
1. drip pan
4. cooking grid
2. drain pipe
5. drip bucket
3. drain valve
Install the drain pipe into the female threaded coupling in the right end
of the drip pan. Tighten with pliers or pipe wrench.
Carefully set the drip pan into grill bottom using the lift tabs at each
end. Line up the drain pipe with the hole in the grill bottom making sure
pipe extends out bottom and drip pan is setting level in its brackets.
Install the brass drain valve onto the drain pipe. Hand tight only is
sufficient. DO NOT TIGHTEN WITH WRENCH OR PLIERS! (During
the course of maintenance of the grill you will need to remove the
drain valve.)
Now place your cooking grid into the grill.
Check all bolts and nuts for tightness and then proceed
to leak testing.
❍
❍
❍
❍
FIGURE 6a
HOLLAND APEX BODY ONLY GRILL
INSTALLATION INSTRUCTIONS
WARNING:
YOUR ISLAND MUST BE MADE FROM
NON-COMBUSTIBLE MATERIALS.
CLEARANCE WARNING: Minimum clearance from sides and back to
combustible construction, 18 inches (50CM) from sides, 18 inches
(50CM) from back. It is very important to observe and maintain the
proper clearances from combustible materials.
Step 1:
Set your grill assembly into the island cutout.
Slide the whole assembly back until the front panel
touches the front of your island.
Step 2:
Turn off gas supply before attempting to connect the
grill to the main gas supply. Remove the control panel.
Connect your gas supply to the on/off valve on the
grill. Be sure to leak test unit prior to use.
See Page A-12 for the Soapy Water Test.
Step 3:
Hang your drain bucket onto the bucket bracket
underneath your grill.
FIGURE 6b