Holland Grill APEX BH421-SS5LPB Instruction Manual - page 8
A-5
Install control knobs. Push black igniter knob
firmly until it snaps into place, once installed correctly, it should not
come off easily. Secure silver gas control knob to post by tightening set
screw. Use small allen wrench provided.
Step 7.
Refer to Figure 5. Select the following items:
1. Grill bottom assembly
2. Grill lid
Place the lid onto grill bottom assembly. Fasten the body hinges to the
lid assembly using 1/4-20 x 5/8 hex head bolts and lock washers.
Tighten all 8 hinge bolts completely.
Open lid just enough to insert lid stop into slot in lid end panel. Then,
insert a T-Nut through single hole in lid stop. Insert 10-24 screw with
lock washer into the hole in the lid end panel and screw it into the
T-Nut. Tighten completely. Repeat for opposite side.
Step 8.
Refer to Figure 6a. Select the following items:
1. smoke stacks
2. handle and brackets
3. thermometer
Open the lid fully. Using the 10-24 x 1/2 round head Phillips screws,
lock washers and hex nuts fasten the smoke stacks to the grill lid as
shown. Tighten securely.
Install the thermometer through the small hole in the center of the lid
near the smoke stacks. Using a 1/2” wrench, VERY GENTLY, snug
thermometer securing nut. VERY IMPORTANT: DO NOT OVER-
TIGHTEN.
Select the two handle brackets and handle. First attach the brackets to
the lid using 10-24 X 1/2 carriage bolts, lock washers and hex nuts. DO
NOT FULLY TIGHTEN AT THIS TIME.
Now place tube handle between handle brackets and secure with 1/4-
20 X 1” round head Phillips screw and lock washer as shown. Tighten
completely.
Now go back and tighten completely the handle brackets to lid
❍
❍
❍
❍
❍
❍
❍
FIGURE 5
FIGURE 4b
❍