Holland Grill companion Instruction Manual - Assembling Your Grill
BH212 MG-2
MG2-5
COMPANION GRILL OWNERS MANUAL
ASSEMBLING YOUR GRILL
3. Locate the cooking grid and place in into position in the grill body bottom so it is resting on the flanges of the drip pan.
Your Companion grill is now complete and ready for use except for the items installed at time of operation. See “Preparing Your Grill
For Use” below for directions on installing the regulator and LP cylinder and preparations for lighting and operation.
NOTE: Operation by ADULTS ONLY. NOT for operation by children or minors
INSTALLING REGULATOR
1. Installation is the same for either the type 1 or 2 regulator, the mounting hub portion is the same.
2. Locate the gas/valve regulator. Refer to Fig. 4. The “hub” end of the regulator had a groove in it with a notch out through the face.
The burner has a “pin” stamped into it in the upper inside of the tube portion sticking out of the body. Line up the notch on the
regulator with the pin at the top inside of the burner and slide the regulator into the burner. After inserted, rotate the regulator
with the knob to front to lock into place.
To Remove
Allow grill to cool for 30 minutes. Turn gas know to “OFF” position. Un-thread LP cylinder from regulator per instructions below. Rotate
regulator to “upside down” in burner end to disengage lock groove and slide regulator/valve OUT from burner tube. Store in a clean
secure location for next use.
INSTALLING LP CYLINDER
NOTE: Always make sure the regulator is “locked into” the burner end before attaching LP cylinder.
Be sure the gas control know is in the “OFF” position. Refer to Fig. 5. Check to make sure the threads on the cylinder and in the
regulator are clean. Thread LP cylinder so threads engage correctly to achieve proper connection. Hand-tighten cylinder only.
PREPARING YOUR GRILL FOR USE
INSTALL
REMOVE