Hollis Explorer User Manual - page 125
Approved Products and Glossary
Approved Products
| 119
CO
2
SCRUBBER MATERIAL
Intersorb 812 (8-12 mesh) or Sofnolime (8-12 mesh)
OXYGEN SENSORS
Hollis EXPLORER Sensors
CLEANING PRODUCTS
Steramine 1-G Tablet
White Vinegar
Crystal Simple Green® or Dawn (or similar mild) dish detergent
MAINTENANCE PRODUCTS
Dow Corning® 7 Silicone (non-O
2
clean parts only)
CRISTO-LUBE® MCG 111
Tribolube 71®
DeoxIT® Gold GN5 Electrical Contact Cleaner
Other products not listed may be appropriate for use with the Explorer. If
there is a particular product which you wish to use, please call the factory
to make sure the product does not contain chemical components which
may be harmful to components within the rebreather or the diver.
CAUTIONS: Consult manufacturer Material Safety Data Sheets
for further safety recommendations for these materials.
Never use the following products or families of products on
ANY part or surface of the Explorer rebreather:
- Products which contain alcohol, high concentrations of chlo-
rine, ammonia, gasoline, Benzene or any petrochemical-based
solvent (Basically, any product with the suffix “ene” in it.)
- Polishes, wax, automotive cleaning products.
- Glues, binding agents, plastic fillers other than those spe-
cifically listed in the “maintenance and troubleshooting” or
“approved products” sections of the manual.
DANGER: Never attempt to clean your rebreather, or any part
of your rebreather in a dishwasher or any other type of ma-
chine that employs high pressure jets of cold, warm or scald-
ing hot water.
8
.1
!
CAUTION