Hollis Explorer User Manual - page 92
86 |
FILLING STEPS – PROPACK VERSION ONLY
DANGER: DO NOT perform this action unless you are certified
to do so.
1. Remove the Filter from the Canister. Inspect the quad ring for cleanli-
ness/damage and clean/replace with a small amount of grease (Fig. 4.9).
2. Unscrew the yellow top nut and canister lid and inspect the meshes for
damage.
3. Remove any excess absorbent stains from the canister components
with warm, soapy water and then rinse in fresh water. Then allow it to dry.
4. Fill the canister in a well-ventilated environment. Raise the absorbent
barrel at least 200mm (8 inches) above the canister to allow dust to blow
away as you fill. Fill to the top of the canister, making sure absorbent is at
an even depth across the canister.
5. Pack the absorbent by tapping the sides for at least 1 minute.
6. Fill to the top again.
7. Pack the absorbent by tapping the sides for at least 1 minute
8. Refill with Absorbent to the top. Tap down as required until you can fit
the lid. Refit the lid and the spring (under the yellow nut).
9. Screw down the top nut.
10. Wipe any dust from inside the canister.
11. Look into the Canister head and run your finger around the sealing
face for the quad-ring removing any debris.
12. Insert the filled Filter into the Canister.
13. Refit the Right Hand end cap.
14. Dispose of old absorbent as normal household waste. Do not leave it
lying around for animals to ingest.
Filling instructions are also found on the side of the canister tube.
FILLING STEPS – PRE-PACKED VERSION ONLY
1. Remove the Filter from it sealed packaging.
2. Inspect the quad ring for cleanliness/damage
3. Apply a small amount of grease to the quad ring.
4. Wipe any dust from inside the canister.
5. Install the filter.
6. Refit the Right Hand end cap.
7. Dispose of old absorbent filter as normal household waste. Do not leave
it lying around for animals to ingest.
Fig. 4.9
!