Hollis Explorer User Manual - page 26
20 |
Fig. 3.2
Fig. 3.3
Fig. 3.4
In addition, it can be viewed at any point on the dive by pressing any
button and selecting STAT from the pop-up menu using a short push of the
right button. It can also be accessed in service mode by selecting STAT (a
short push of both buttons) from the Startup screen. Note that in both cas-
es the STAT button indication is colored blue, as are all button indicators
modified by service mode.
Once in the STATUS screen, a short press of the left or right button scrolls
round the information options. These are:
a. PPO
2
(average of the 3 sensors)
b. CO
2
sensor
c. HP gas
d. Battery life
e. No Decompression Limit (NDL)
f. Decompression Information
g. Filter (CO
2
filter)
h. CNS
i. A general Warnings Window (the ACTION Panel) detailing any alarm in
progress. This mostly displays ‘SYSTEM OK’ or ‘DO PREDIVE as in the
above example unless there is another fault to report.
SERVICE MODE
Service mode is accessed in the Setup Menu.
With this mode set, each pre-dive screen shows additional text information
relevant to the test being performed.
Also, it enables an extra (blue) STAT button on the Startup screen (Fig.
3.2), which if selected with a long push of both buttons (not indicated), will
allow access to detailed service sub-screens. Your Hollis dealer will use
information on these screens to assist with any servicing required. A short
push of STAT will just display the STATUS screen and relevant resources
as during a dive.
To enable fault diagnosis put the EXPLORER into Service Mode. Having se-
lected STAT with a long hold of both buttons from the Startup screen you
will access two extra screens (Fig. 3.3, 3.4) (plus alarm and metric screens,
not shown).