Home Advances Solar 6RHAS100LGR User Manual - page 8
8
AdjuStinG tHe AnGLe OF tHe SOLAR Led SecuRity LiGHt
The Solar LED security light/camera can be swiveled up and down, and left to right, according to your needs. To
adjust it, first loosen the dial counterclockwise, then adjust the head. Then tighten the dial clockwise. See Fig. 8.
FIG. 8
dial
cHARGinG tHe bAtteRy
There are two ways to charge the battery: by solar panel or by AC adapter. Please note that charging by AC adapter
requires the purchase of equipment not provided.
by SOLAR pAneL: Unscrew the waterproof cover and remove it.
Make sure that the ON/OFF switch is in OFF position, then replace
the waterproof cover and screw back on tightly. Before using the
Solar LED security light for the first time, leave the ON/OFF switch
in the OFF position for at least four (4) sunny days with the solar
panel placed in direct sunlight. This will ensure that the battery
has a full charge prior to motion sensor adjustment and normal
operation.
by Ac AdAptOR (nOt incLuded): Unscrew the waterproof
cover and remove it. Make sure that the ON/OFF switch is in OFF
position. Plug a 4.5–5V / 500mA AC adapter into the DC Jack, then
into a power outlet. See Fig. 9.
FIG. 9
dc jack
ac adapter
(not included)
SettinG up And OpeRAtinG tHe SecuRity LiGHt
SettinG tHe wORkinG mOde
After the initial battery charging, remove the waterproof cover, if
necessary, to adjust the working mode. See Fig. 10.
OFF Position for delivery or for long periods of non-use.
Position for initial charge before first use.
On Daytime: camera on.
Nighttime: both camera and light on.
When you are finished adjusting the working mode, replace the
waterproof cover, making sure to tighten the screws carefully. The
Solar LED security light is ready for use.
FIG. 10
OFF/ON
switch
slot for SD
memory card
USB port