Home Of Ultra AX314 Installation and user manual - page 6
6
HOW TO MAINTAIN YOUR AX314 / AX315 / AX316 SHOWER
5. Re-Fit the front cover (see Diagram 5), and secure by replacing the top and bottom fastening screws.
a.
Ensure knob “A” is aligned to the “High” position.
b.
Ensure knob “C” is aligned to “12 o’clock.
c.
In the main body of the shower, turn the “Camshaft” as shown.
d.
In the main body of the shower, turn the “Numbered Dial” fully clockwise until it is at the position
shown. Note:- this instruction should be used if the “Drive Dial” becomes accidentally dislodged.
e.
Fit the front cover of the shower to the main body.
Ensuring that the knobs correctly engaged to their mating component.
f.
Check that knob “A” has been correctly aligned by ensuring that all 3 power settings can be selected.
g.
Check that knob “C” has been correctly aligned by turning anti-clockwise and ensuring that knob turns
approximately 1 full turn and when turned back fully clockwise, returns to “12 o’clock”.
6. Fit the shower hose, and operate the shower first without the handset to flush out particles,
fit the handset and then operate the shower as on page 7 or 12 and check:
a. That the water gets to a satisfactory temperature and water flow can be adjusted by control knob “C”.
b. Power selection operates in all 3 positions, giving a change in water temperature and that the power
indictor lights functions correctly.
c. Check again for leaks
d. That the holes in the shower handset are not blocked
7. DEMONSTRATE OPERATION TO USERS
It is recommended that the shower unit and hose etc. be cleaned using a soft cloth and that the use of
abrasive or solvent based cleaning fluid be avoided, especially on any plated finishes.
We recommend that before any cleaning, the isolating switch be turned off, thus avoiding accidentally
switching on the shower.
WARNING: YOU MUST REGULARLY INSPECT THE SHOWER HOSE FOR WEAR AND DAMAGE.
REPLACE IF NECESSARY, OR EVERY TWO YEARS, WITH OUR APPROVED PART.
WARNING: IN ORDER TO MAINTAIN THE PERFORMANCE OF YOUR SHOWER,
YOU MUST CLEAN THE SHOWER HANDSET REGULARLY
All water contains particles of lime-scale, which build up in the shower handset and
unit reducing the performance.
It is therefore important to clean the shower handset by simply rubbing the rubber
nozzles, or soaking in a proprietary lime-scale remover and rinsing thoroughly before use.
NOTE: After use it is normal for some water to drip from the shower handset for a
few moments. This inhibits lime-scale build-up over prolonged use.