Home Of Ultra AX314 Installation and user manual - page 8
8
SELF HELP
If the shower is not working satisfactorily, make the following checks before calling out the installer.
Any one of these adjustments could restore the performance.
The shower cycles
from HOT to COLD
The shower temperature is set too hot causing the thermal cut-out (safety
device) to operate.
Turn knob “C” clockwise(direction of the “Black arrows”) to increase water flow.
Slowly increase the water temperature by turning knob “C” anti-clockwise in the
direction of the “red arrows” until a comfortable showering temperature has
been reached.
You MUST WAIT approximately 20 seconds for each adjustment to affect the
water temperature.
“Med (medium)” setting may need to be selected.
Water too HOT
Increase water flow by adjusting knob “C” clockwise (direction of the “Black
arrows”).
“Med (medium)” setting may need to be selected.
Increase pressure to water supply e.g. fully open service valve or stop cock.
Check hose is not kinked restricting the water flow.
Clean shower handset.
Water too COLD
Check power is on by neon being illuminated.
Decrease water flow by adjusting Knob “C” anti-clockwise (direction of the “red
arrows”).
“High” setting may need to be selected.
Select inner or outer only handset spray pattern.
Spray pattern poor Clean the shower handset.
Water takes longer
to heat up
Thermal cut-out has operated after previous use (“Overheat” light is on)
(automatically resets when unit cools down)
“High” setting may need to be selected.
Water goes cold
while using
shower
Check neon light is on.
Check water pressure has not fallen so far as to let pressure switch cut out,
e.g. Another tap drawing water off.
Raise position of shower handset.
Water continues to
flow when
button “B” pressed
This is normal.
The shower includes a shutdown feature that means the water will continue to
flow for up to 7 seconds after button “B” has been pressed to stop the shower.
Broken parts
Please contact our spares department on 0844 372 7750 (UK only).
Fitting instructions are provided with most spares
Please Note:- The fitting of Spare Parts must be supervised by a suitably qualified person.
White 2 metre Shower Hose
Cat No. 83792578
Front Cover
Cat No. 93590341
Chrome 1.25m Shower Hose
Cat No. 93797641
Tank-Base Assy (7.2kW)
Cat No. 93597848
Chrome Standard Accessories
Cat No. 83595317
Tank-Base Assy (8.5kW+) Cat No. 93597849
Chrome Multi-Mode Accessories
Cat No. 83595318
Solenoid Valve
Cat No. 93590722
Chrome Curved Accessories
Cat No. 83595320
Cam and Adaptor Kit
Cat No. 93590793
Curtain and Rail Pack
Cat No. 83792812
Tank Clip
Cat No. 93768309
Curtain and Rail Pack with
PRV Washer
Cat No. 93795817
Non-Slip Mat
Cat No. 83792811
Cylinder “O”-Ring
Cat No. 93795809
WRAS listed Water Isolating Valve Cat No. 93792452
Thermal Cut-Out 50/88°C
Cat No. 93597836
Phased Shut-Down PCB
Cat No. 93597813
Phased Shut-Down Relay
Cat No. 93597878
Handset
Cat No. 93597864
Chrome Shower Hose 1.25m Cat No. 93797641
WHAT TO DO IF THINGS GO WRONG (1)
ADDITIONAL ACCESSORIES COMMON SPARE PARTS
Additional accessories and spare parts can be
supplied against any Credit or Debit cards
from Home of Ultra Hotline 0844 372 7750